Porsche 718 Cayman GT4 with yellow carbon-ceramic brake calipers

Pagid RSC1 for Carbon-Ceramic Rotors: Track Days on PCCB

If your car has factory carbon-ceramic rotors — Porsche PCCB, BMW carbon-ceramic brakes and similar — almost every track pad in our other guides is off the table. Race compounds designed for iron discs can damage ceramic rotors, and a set of ceramic rotors costs far more than any pad. RSC1 is the pad Pagid makes for exactly this case, and it is the one owners on ceramic-braked Porsches recommend.

This article is part of our guide to Pagid pads for track cars. Every shape we list is in the RSC1 collection.

What Pagid says

RSC1
Family RSC — racing brake pads for ceramic composite discs
Friction "Medium friction coefficient"; "good allround performance characteristics"
Rotors "Disc friendly"; "race and track day compound for all known types of ceramic brake discs"
Range RSC 2 (medium-high) and RSC 3 (high friction) are Pagid's more aggressive ceramic-disc compounds

BimmerWorld, which sells RSC1 for BMW carbon-ceramic brakes, calls it "a '+1' pad upgrade over the factory CCB pads," says it "is compatible with new or used carbon rotors," and that "you can swap back to your factory CCB pads at any time."

What owners say

On the Rennlist 991 GT3 forum, the consensus is short: "I understand that Pagid RSC1 are the go to pads for PCCB's." A dealer in the same thread called it "the most mild-mannered and street-friendly" option, with "a lower temperature threshold, but I haven't heard of anyone melting a set of these." An owner who switched wrote: "The RSC1s have a little less initial bite vs OEM (a good thing)," adding "I'll take rotor life over a more aggressive pad." Another put the priority plainly: "Absolutely not willing to increase wear on the PCCBs in the quest for slightly better track use."

The trade-off is pad life. On an older 997 GT3 with PCCB, an owner reported the "rears went from 90% to maybe 20% in just one day of hard-charging driving," compared with "at least two full days with OEM pads on the same track." He still liked them: "They're gentler on the rotors vs. OEMs too," and "if you drive to track, noise is not a concern--these pads are socially acceptable (unlike RS29's)."

What about running other pads on ceramics?

You will find people who do. Some vendors on Rennlist report that "even some Porsche dealerships order RSL29 to use on PCCB," and others run RSL1 on aftermarket ceramic discs. Dealers who sell both are firm the other way: one states that "race compounds designed for iron discs should not be used on ceramic composite discs, no exceptions," and BimmerWorld's RS29 listing says "DO NOT use these pads with carbon-ceramic rotors!" We follow Pagid: on ceramic rotors, use the RSC family.

When to convert to iron instead

If the car is going to see a lot of track time, the cheaper long-term answer is often iron rotors and an ordinary track pad. BimmerWorld's note on RSC1 is worth reading twice: "operating within a higher temp zone will degrade carbon discs faster. If long-term track use is planned we advise switching to our iron brake conversion." Iron conversions open up the whole Pagid range — RS29, RSL1 — and PFC as well.

Which cars we stock it for

Car Our RSC1 pads
Porsche 991 GT3 / GT3 RS / R / Turbo, 718 GT4 4.0, 918 (ceramic brakes) — front U4927
Porsche 991 GT3 / Turbo, 981 / 718 GT4, 992 GT3, 918 — rear U4925
Porsche 991 Carrera / Carrera S with ceramic brakes — front U4908
Porsche 991 Carrera S — rear U4909
Porsche 997 — rear U8006
Ferrari F430 with ceramic brakes — front U8083

RSC1 pads ready to ship

RSC1 Front — 991 GT3 / 718 GT4 PCCB (U4927)

RSC1 Front — 991 GT3 / 718 GT4 PCCB

Pagid U4927

$788.24

Shop now ›
RSC1 Rear — 991 / 992 GT3, GT4 (U4925)

RSC1 Rear — 991 / 992 GT3, GT4

Pagid U4925

$630.59

Shop now ›
RSC1 Rear — 991 Carrera S (U4909)

RSC1 Rear — 991 Carrera S

Pagid U4909

$618.34

Shop now ›

Browse every shape in the RSC1 collection.

The Bottom Line

On factory carbon-ceramic rotors, RSC1 is the track-day pad to use. It is milder than OEM, kind to the rotors, and quiet enough to drive to the track; expect it to wear faster than an iron-rotor race pad. If you plan a lot of track days, price an iron conversion before you buy pads.

Not sure of your shape? Tell us the car and caliper and we will confirm before you order.

Related guides

Every RSC1 shape we stock, front and rear.

Shop Pagid RSC1 pads Back to the Pagid guide, car by car ›
Back to blog

Leave a comment

Please note, comments need to be approved before they are published.